An unusual mixed-valence Cu(I)-Cu(II) 3-D framework

The reaction of Cu(CH(3)CN)(4)ClO(4) with 2-pyridylacrylic acid (2-HPYA) affords an unusual mixed-valence Cu(I)-Cu(II) 3-D framework ([Cu(II)(2-PYA)(2)](3).[Cu(I)(2-PYA)](2).(H2O)(2))n (1) with a novel topology which features Cu(II) dimeric units (or paddle-wheel unit). The almost perpendicular coordinating direction between the N atom of pyridyl and the O atom of carboxylate groups may be responsible for the formation of such a novel network.     

HY沸石上2,6-二叔丁基萘的择形合成

 研究了脱铝HY沸石（n（Si）／n（Al）＝3．8）上萘（naph）的\r\n选择性叔丁基化反应．结果表明，八面沸石对该反应过程有较好的择形\r\n催化作用，两种异构化产物（2，6－二叔丁基萘和2，7－二叔丁基萘）\r\n之间存在着热力学平衡，即两种异构化产物可在酸性中心位上相互转化\r\n．在以叔丁醇为烷基化试剂，WHSV＝2h－1，n（t－BuOH）／n（naph）\r\n＝3，反应温度为120℃的反应条件下，萘的转化率可达98．43％，β－\r\n位选择性可高达100％，二叔丁基萘收率可达74．34％，2，6－二叔丁\r\n基萘／2，7－二叔丁基萘质量比为6．24．     

SAPO-34分子筛骨架稳定性的研究

利用差热分析，原位ＸＲＤ技术，高温条件下的焙烧和水蒸气处理并关联其催化性能变化，研究了ＳＡＰＯ－３４分子筛的热及水热稳定性，差热分析结果表明，ＳＡＰＯ－３４的骨架破坏温度高于１３００Ｋ，原位ＸＲＤ跟踪研究证实，ＳＡＰＯ－３４分子筛原粉在高温焙烧以除掉有机胺及随后的降温过程中无明显的骨架破坏；而焙烧型ＳＡＰＯ－３４在空气中放置一定时间后，水分子吸附微孔中明业降低样品的ＸＲＤ峰强度，且降低幅度随放置时     

A novel approach to carbon hollow spheres and vessels from CCl4 at low temperatures

Carbon hollow spheres (400-600 nm) and vessels (400 nm x 3000 nm) have been synthesized from sp3-CCl4 at 190 and 230 degrees C, respectively. The HRTEM images and Raman spectra reveal the sp2 nature of the as-obtained products, indicating that the transformation from carbon sp3 to sp2 occurs in the reactions. The possible mechanism has also been proposed.     

Investigation on relation between TL and OSL of Li2B4O7:Cu, In

Polycrystal Li₂B₄O₇ (LBO) doped with Cu and In was prepared and then sintered at different temperatures. X-ray diffraction (XRD) was applied to get the parameters of the LBO structure, thermoluminescence (TL) and optically stimulated luminescence (OSL) were measured, and a second-order exponential decay model was fitted to the OSL decay curves. The results indicate that the original number of OSL traps that have captured electroncs is linearly related with the sum of TL decay during the OSL process. Mean decay constant of OSL is related to the sintered temperature. The possible reason is that the sintered temperature affects the crystal sizes of the polycrystal, and consequently affects the stimulating lights’s intensity and the photoionization cross-section of the electrons, which have been captured by the traps. __________ Translated from Acta Scientiarum Naturalium Universitatis Sunyatseni, 2005, 44(4) (in Chinese)     

Novel preparation of organic polymer-based monolithic column by microwave irradation

Microwave irradiation was firstly attempted for the preparation of organic-based monoliths of poly（styrene-divinylbenzene- methacrylic acid）, which single step in situ polymerization was carried out during 15 min. The colunm permeability, electrophoretic and chromatographac behaviors were comparatively evaluated using pressure-assisted CEC, GEC and low pressure-driven separation modes. The largest theoretical plates for the preparing column could be close to 18,0000 plates/m for thiourea in the mode of p-CEC. It provided a viable alternative to traditional initiation means for the perparation of monolithic capillary columns.     

一种新的库仑微水滴定仪的设计方法

在传统微库仑滴定仪原理的基础上，利用８７５１单片机和微机，采用对电解电流时间调制的方法以及测量精度为准则判断滴定终点，从而大大地提高了仪器的测量精度和重复性。     

Air sampling of aromatic hydrocarbons in the presence of ozone by solid-phase microextraction

Effects of ozone on air sampling of standard gas mixtures of aromatic hydrocarbons were tested using solid-phase microextraction (SPME). Standard concentrations of ozone ranging from 10 ppb (v/v) to 6400 ppm (v/v) were generated using an in-house built ozone generator based on corona discharge. Effects of temperature, discharge voltage, and oxygen flow on the ozone generation were tested. The working dc voltage had the greatest effect on generated ozone concentration and was proportional to the ozone concentration. Generation temperature and oxygen flow rate were inversely proportional to ozone concentrations. Produced ozone was mixed with standard benzene, toluene, ethylbenzene, and xylenes (BTEX) gas at less than 100 ppb (v/v). Air samples were collected with poly(dimethylsiloxane) (PDMS) 100 microm SPME fibers and analyzed by gas chromatography (GC)-flame ionization detection (FID) and GC-MS. Significant reductions of BTEX concentrations were observed. In addition, some products of BTEX-ozone-oxygen reactions were identified. SPME worked well as a rapid sampler for BTEX and BTEX-ozone-oxygen reaction products. No significant deterioration of the PDMS coating and no significant reduction of absorption capacity were observed after repeated exposure to ozone.     

丹宁纤维素富集-氢化物发生ICP-AES同时测定水中痕量锗

研究了丹宁纤维素富集10~(-11)g/ml级锗的条件,并考察了地下水中36种共存离子对磷酸介质中氢化物发生ICP-AES测定锗的干扰和消除,应用于测定地下水中的超痕量锗,结果满意,检出限为15ng/L。